Loading... Please wait...

Our Newsletter

Eflite 60-Amp Pro Switch-Mode BEC Brushless ESC

  • Image 1
$4.99 (Fixed shipping cost)

Product Description

Product Description

Key Features

Up to 60-amp continuous current with proper airflow, 75-amp peak
5-volt switch-mode BEC circuit capable of 2.5-amp continuous current on any recommended input voltage
Drives up to 7 analog or 6 digital standard-size servos, with the BEC on any recommended input voltage
3–6S Li-Po, 9- to 18-cell Ni-Cd/Ni-MH input voltage
Finned heat sinks
Programmable motor braking
Safe power-arm mode prevents accidental starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 70% of battery starting voltage
Programmable soft start for helis and airplanes
Auto motor shutdown if signal is lost or there is interference
Programmable timing—5 user-selectable ranges for use with a larger variety of brushless motors
Programmable throttle input range (1.1–1.9 ms or 1.2–1.8 ms)
Utilizes new smaller MOSFET technology to minimize weight
Radio system power on/off Switch
Pre-wired connectors—E-flite® EC3™ on battery input and 3.5mm female gold bullets on motor output leads

When performance matters in your high-current applications, look no further than the E-flite® 60-amp Pro switch-mode ESC. This is a high-quality, efficient sensorless brushless electronic speed control with an integrated switch-mode BEC. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. It is capable of up to 60 amps continuous current when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-size servos with the BEC on any recommended input voltage. Featuring an exposed, finned heat sink aluminum case with lightweight plastic end-caps, safe power-arming along with advanced programmable features such as low voltage cutoff, braking, timing, throttle input range and more, the E-flite 60-amp Pro switch-mode ESC is truly a ‘pro series’ electronic speed control.3


Amperage: 40-60
Brake: Yes - Programmable
Cells w/BEC: 3-6S Li-Po or 9-18 Ni-MH/Ni-Cd
Continuous Maximum Current: 50 - 75A
Height: 0.50 in (13mm)
Input Connector Types: EC3
Input Voltage: 10.8V - 22.2V
Length: 3.00 in (76mm)
Momentary Peak Current: 75A (15 sec)
Output Connector Types: 13AWG with 3.5mm female gold bullet connectors
Type: Brushless
Weight: 2.3 oz (66 g)
Width: 1.30 in (33mm)
Wire Gauge: 13AWG

Find Similar Products by Category

Add to Wish List

Click the button below to add the Eflite 60-Amp Pro Switch-Mode BEC Brushless ESC to your wish list.

You Recently Viewed...