Loading... Please wait...

Our Newsletter

Futaba 6EX 2.4GHz Heli R617FS 4-S3001 - FUTK6902

  • Image 1
Free Shipping

Product Description

This is the Futaba 6EX Heli Transmitter with the 2.4GHz FASST system,
R617FS 7-ch Receiver and four S3001 Ball Bearing Servos.

FEATURES: Futaba's FASST (Futaba Advanced Spread Spectrum Technology) shifts very quickly virtually eliminating signal conficts and interruptions unlike other 2.4GHz systems that only stay on one or two frequencies.
R617FS high sensitivity receiver weighs only 0.25oz (7g) without case yet is a full range system for all aircraft from giant scale to Park Flyer applications-no need to buy separate receiver for specific aircraft rubber grommets installed where antennas exit to eliminate stress and fraying of the wires.
Dual antenna diversity enables FASST system to automatically and seamlessly select the best reception between the two antennas built into the receiver ensuring that the aircraft stays under constant control of transmitter regardless of altitude.
Pre-Vision Packet Screening technology scans incoming data for potential problems and applies sophisticated error correction techniques for solid impenetrable link with model
Easy Link system features a unique ID code in the transmitter that links to the receiver insuring that receiver only follows commands from this transmitter-with over 134 million possible codes there is no chance for a conflict
No hassle Fail Safe programmed through transmitter-no complicated set-up steps or binding plugs
When performing a ground check, the Power Down function allows modeler to reduce power from up to 50+ paces away-like retracting the antenna on a conventional transmitter
Purpose built custom IC chips for key functions; no off-the-shelf IC chips
One year limited warranty

Standard Programming Features:
Trainer function-transmitter can be master or student, compatible with other Futaba systems
Six model memory
Servo reversing
End point adjustment
Airplane or heli programming
Dual Rate /Exponential for ailerons, rudder and elevator
Fail Safe-safety throttle setting in case of transmitter signal loss
Battery Fail Safe-safety throttle setting in case of signal loss
Stick Mode-Choose from Modes 1-4
Changeable Throttle Stick-ratchet for airplanes or smooth for helis
Adjustable Stick Length

Airplane Features;
Programmable Mixing (1 & 2) any two channels can be combined
Pre-Programmed Throttle Cut for safely shutting off engine
Wing mixing for flaperon, flap trim, V-tail and elevon

Helicopter Functions;
Three swashplate types
Five-Point Normal and Idle Up Throttle/Pitch Curves
Revo, Gyro and Swash to Throttle mixing
Swash AFR Adjustable Function Rate for use w/ 3S or 3E swash types

INCLUDES: Futaba 6EX Transmitter
NT8F600B 9.6V 600mAh NiCd Transmitter Battery, FUTM1440
FBC-19B(4) 120V AC Battery Charger, FUTM1830
Four S3001 Ball Bearing Servos, FUTM0029
R617FS Receiver, FUTL7627
Switch Harness-J Style Connector SWH13 FUTM4370
Neck Strap, FUTM5690
Servo mounting hardware and extra horns

REQUIRES: 4.8V receiver battery of modeler's choice

SPECS: Transmitter;
Power Supply: 9.6V
Current Drain: 170mA

Size: 1.6 x 1.1 x 0.35" (40 x 27 x 9mm)
Power Requirement: 4.8 - 6V
Current Drain: 80mA (at no signal)
Weight: 0.35oz (10g) with case
0.25oz (7g) without case

Length: 1.6" (41mm)° @ 4.8V
Width: .8" (20mm)
Height: 1.4" (35mm) at 4.8V
Weight: 1.6oz (45.1g)t 6.0V
Torque: 33.3 oz-in at 4.8V 41.6 oz-in. at 6V
Transit: .23 sec/60° @ 4.8V .19 sec/60° @ 6V
Connector: "J" type with approx. 5" (127mm) long wire

Find Similar Products by Category

Add to Wish List

Click the button below to add the Futaba 6EX 2.4GHz Heli R617FS 4-S3001 - FUTK6902 to your wish list.

You Recently Viewed...